
Environmental Remediation Drilling
Safety Guideline
Page 106 of 132
JOB SAFETY ANALYSIS FORM
JOB TITLE/TASK: Pre-Ground Disturbance Clearance Activities
PROJECT ID PROJECT MANAGER:
DATE: REVISION: HEALTH/SAFETY DIRECTOR:
RECOMMENDED PERSONAL PROTECTIVE EQUIPMENT (PPE): _X_ Safety Glasses w/ Sideshields _X_ Steel-toed Boots
_X_
Hard Hat _X_ Nitrile Gloves _X_ Leather Work Gloves _X_ Other _As specified in HASP and JSA Job Step_______
JOB STEP
POTENTIAL
HAZARDS
PREVENTATIVE/CORRECTIVE ACTION
APPLIES TO
PROJECT
(Y/N)
adequate assistance
Bend and lift with legs and arms, keeping back straight
Wear appropriate PPE including leather gloves, long sleeves and
pants, and steel-toed boots
Impact to
Subsurface Lines
Ensure all underground features have been identified in area per
Subsurface Clearance Protocol (SCP) prior to start of activities
Equipment Rollover If soil appears unstable, the soil should be assessed by a qualified
professional engineer to ensure safe conditions with implementation
of design control measures prior to start of work
Soil
Clearance
using hand
tools or heavy
equipment
(probe, auger,
air knife rig,
backhoe)
Heavy Equipment
Movement
Heavy equipment should be equipped with back-up alarm
When approaching heavy equipment, approach should be made from
the front ensuring eye contact is made with operator
Physical Injury from
Managing
Equipment
Take breaks if feeling faint or overexerted
Ignition Sources Ensure equipment properly bonded and grounded
Use sufficient hose so that equipment does not have to be located in
critical zone
Apply water as necessary to address sparking potential if equipment
comes in contact with rocks/buried objects
Equip heavy equipment with non-sparking bucket/blade
High Noise Levels Hearing protection required when working around operating
equipment if levels are suspected to be >85 dBA (if have to yell to
person at a dist of 3 ft to be heard, likely exceeding 85 dBA).
Airborne Debris Wear appropriate PPE including leather gloves, long sleeves and
pants, and face shield or safety glasses with side shields
Vapors and
Airborne
Particulates
Monitor air concentrations using direct-reading, real-time instruments
such as OVM and Draeger tubes
Stop work if hazardous conditions (explosive atmosphere, O
2
deficient
atmosphere) identified until precautions are taken
Wear appropriate PPE including dust masks and respirators
Stay upwind (use flagging or similar device to indicate wind direction)
Impact to Ensure underground features in area have been identified to extent
Comentários a estes Manuais